基于STM32的可遥控智能跟随小车设计
DOI:
作者:
作者单位:

西南交通大学电气工程学院成都611756

作者简介:

通讯作者:

中图分类号:

TP242.6

基金项目:


Remote controlling and intelligent following car design based on STM32
Author:
Affiliation:

Schoolof ElectricalEngineering ,Southwest Jiaotong University,Chengdu 611756, China

Fund Project:

  • 摘要
  • |
  • 图/表
  • |
  • 访问统计
  • |
  • 参考文献
  • |
  • 相似文献
  • |
  • 引证文献
  • |
  • 资源附件
  • |
  • 文章评论
    摘要:

    针对物品搬运时人类双手仍无法完全解放的现状,设计并实现了一种基于STM32、超声波测距以及比例控制算法的可遥控智能跟随小车。小车以STM32为控制核心,有智能跟随和红外遥控2个模式可选。跟随模式下用2个安装在前端的超声波模块分别实时测量小车与目标之间的距离,单片机采用比例控制算法,根据实测距离控制左右电机转速;遥控模式下单片机根据接收到的红外遥控信号控制小车的运动方向。试验结果表明:小车在2 m以内准确跟随几率大于95%、响应时间小于250 ms。该设计实现了小车对目标的360°智能跟随以及在必要情况下对小车的遥控操作,系统可靠,较人性化。

    Abstract:

    Currently human hands are still not liberated when men carry things. This paper designs and implements an remote control and intelligent following car based onSTM32, ultrasonic ranging and proportional control algorithm.The car uses STM32 as its control center, and the intelligent follower mode and the infrared remote controlling mode are both available for the car. There are two ultrasonicmodulesinstalledon the front to watch thedistance between the car and the targetat each time under the following mode.SCMadopts proportional control algorithm and controls the motor speed on the left and right side according to the watcheddistance.Itcontrols the moving direction of the car according to the received infrared signal under remote controlling mode. Experimental results show the car accurately follow probability greater than 95% and response time less than 250 ms within two meters. This design accomplishes the goal that a intelligent car can automaticallyfollow the targeteven turning 360°and peoplecan control the car remotely when necessary.The system is reliable and convenient to people.

    参考文献
    相似文献
    引证文献
引用本文

刘磊,孙晓菲,张煜.基于STM32的可遥控智能跟随小车设计[J].电子测量技术,2015,38(6):31-33

复制
分享
文章指标
  • 点击次数:
  • 下载次数:
  • HTML阅读次数:
  • 引用次数:
历史
  • 收稿日期:
  • 最后修改日期:
  • 录用日期:
  • 在线发布日期: 2016-05-27
  • 出版日期: